Speedpuls 4P 12V

fiz-o-matic

€74.00*

Prices incl. VAT plus shipping costs

Available, delivery time: 2-12 Tage

Product number: SP-4P-12V

Product information "Speedpuls 4P 12V"

Signal generator for a digital speedometer signal.

The 4P module generates 4 electrical pulses per speedometer shaft revolution. With a k-number of approx. 1000 (T3-Syncro, Golf2, etc.) this results in 4000 pulses per revolution.

2WD speedometer: W=500 ⇢ 500 speedometer shaft revolutions per km ⇢ with 4P module ⇢ 2000 pulses per km
4WD speedometer: W=1000 ⇢ 1000 speedometer shaft revolutions per km ⇢ with 4P module ⇢ 4000 pulses per km
Golf MK2 speedometer: W= 960 ⇢ 960 speedometer shaft revolutions per km ⇢ with 4P module ⇢ 3840 pulses per km

Depending on the control unit/signal processor unit used, a tachometer signal can be generated with 5V or 12V.

Via a solder bridge, the signal voltage can also be adjusted subsequently.

0 of 0 reviews

Leave a review!

Share your experiences with other customers.

Login

Your email address

Your password

No reviews found. Share your insights with others.

Passend dazu:

Digital Clock LCD Screen

Repair kit for the digital clock display suitable for VW T3 various VW Golf 2 and other VW models. Often the LCD of the digital clock in the cockpit is partially or completely leaked. Remedy is then only a completely new clock or the replacement of the LCD. In the scope of supply are also new ladder rubbers included PLEASE NOTE: Replacing the LCD does not fix any faults in the wiring or electronics. The installation should not be done by laymen

€24.00*

Details

Instrument carrier repair corners

Repair corners for the instrument holders. If on the tabs the instruments (speedometer, tachometer or analog clock) are broken off, they can be replaced with these corners. These corners are printed from ABS and can be fixed with a little super glue or 2K glue.

€3.00*

Instrument Cluster Repair Corners

This repair corner was specially designed to repair the broken corners on the T25/Vanagon instrument cluster. In all the instrument cluster housings I have seen so far, the corners were torn or partially torn out. As soon as the thread is no longer present, it becomes very difficult to fix the speedometer or tachometer reasonably. Remedy is this corner. They are attached to the housing with a little super glue or with 2K glue. This gives the screws a hold again. These corners are printed from ABS.

€6.00*

Instrument Cluster Repair Corners

From €12.00*

Details

Mutternset Tank- und Temperaturanzeige

Set mit Muttern zur Befestigung der Tank- und TemperaturanzeigeSorgen für den idealen Kontakt für die Anzeigen. Inhalt:4 Muttern M4 aus Messing4 Federscheiben A4 (gewölbt aus verzinkten Federstahl)1 Mutter M2.3 aus Messing1 Federscheibe A2.3 (gewölbt aus verzinkten Federstahl)

€8.00*

OXS LED

Die rote LED für die OXS LED wird anstelle der Diesel LED eingesetzt.Da wo beim Diesel eine gelbe LED ist kann die OXS LED verwendet werden.

€1.00*

Schraubenset Tachogehäuse

Schraubensortiment passend für das TachogehäuseInhalt:10 Schrauben 3,5 x 16Schrauben speziell für ThermoplasteLinsenkopf, Kreuzschlitz H-Phillips

€8.00*

Schraubenset Tachohalterung

Schraubenset für den Tacho zur Befestigung.Ideale Länge in Verbindung mit den Tachogehäuse HalterInhalt:4 Schrauben 4.2 x 19 (Linsen-Blechschrauben mit Phillips-Kreuzschlitz H)4 Unterlegscheiben 4,3 (schwarz verzinkt)

€6.00*

Terminal - Instrument Cluster

Crimp contact for instrument cluster connectorquality: - Reproduction - adjustments may be necessary (remove degree, bend up)VW number: N0171912, N0171914, 000979102

From €1.45*

Details