Repair kit for the digital clock display suitable for VW T3 various VW Golf 2 and other VW models. Often the LCD of the digital clock in the cockpit is partially or completely leaked. Remedy is then only a completely new clock or the replacement of the LCD. In the scope of supply are also new ladder rubbers included PLEASE NOTE: Replacing the LCD does not fix any faults in the wiring or electronics. The installation should not be done by laymen
Repair corners for the instrument holders. If on the tabs the instruments (speedometer, tachometer or analog clock) are broken off, they can be replaced with these corners. These corners are printed from ABS and can be fixed with a little super glue or 2K glue.
This repair corner was specially designed to repair the broken corners on the T25/Vanagon instrument cluster. In all the instrument cluster housings I have seen so far, the corners were torn or partially torn out. As soon as the thread is no longer present, it becomes very difficult to fix the speedometer or tachometer reasonably. Remedy is this corner.
They are attached to the housing with a little super glue or with 2K glue. This gives the screws a hold again. These corners are printed from ABS.
This repair corner was specially designed to repair the broken corners on the T25/Vanagon instrument cluster. In all the instrument cluster housings I have seen so far, the corners were torn or partially torn out. As soon as the thread is no longer present, it becomes very difficult to fix the speedometer or tachometer reasonably. Remedy is this corner.
They are attached to the housing with a little super glue or with 2K glue. This gives the screws a hold again. These corners are printed from ABS.
Set mit Muttern zur Befestigung der Tank- und TemperaturanzeigeSorgen für den idealen Kontakt für die Anzeigen. Inhalt:4 Muttern M4 aus Messing4 Federscheiben A4 (gewölbt aus verzinkten Federstahl)1 Mutter M2.3 aus Messing1 Federscheibe A2.3 (gewölbt aus verzinkten Federstahl)
Schraubenset für den Tacho zur Befestigung.Ideale Länge in Verbindung mit den Tachogehäuse HalterInhalt:4 Schrauben 4.2 x 19 (Linsen-Blechschrauben mit Phillips-Kreuzschlitz H)4 Unterlegscheiben 4,3 (schwarz verzinkt)
